Now, DC power faucet could almost be taken off from the motherboard, be careful, in the touch hole, there�s a copper sleeve connected at the bottom joint of the motherboard and the other side.

Therefore, never force too hard, when you try to pull out the power DC Jack, maker sure the soldering-tin is that thaw out state without pull the sleeve from connected hole, I hope you can understand what I mean.

If you pull out the power DC Jack by force, probably you may also pull the copper sleeve out at the same time. Seriously, I don�t think you want to see such a situation.

There are several pins attach to motherboard. Use the solder iron to desolder these connected pins. Then take off the defective DC Jack. Also to avoid the solder stuck the connected holes. Please use the solder pumps suction to take out the soldering tin.

The DC Jack is separated from the motherboard, leaving the empty holes.